Product characteristics:
Specification | BR-LED-20RL/INS/NG | |
SPD classification according to EN61643-11 | Type 2 + Type 3 | |
SPD classification according to IEC61643-11 | Class II + Class III | |
Nominal a.c. voltage | Un | 230V |
Max. continuous operating a.c. voltage | Uc | 275V |
Frequency | 50-60Hz | |
Norminal discharge current (8/20μs) | In | 5kA |
Maximum discharge current (8/20μs) | Imax | 20kA |
Nominal current | IL | 10A |
Voltage protection level | Up | ≤1.3kV |
Combined impulse | Uoc | 6KV |
Response time | tA | ≤100ns |
Operating temperature range | Tu | -40℃-80℃ |
Operating state / fault indication | green / non | |
Section of cables | 1.5mm² | |
Length of cables | 110mm/150mm | |
Degree of protection | IP65 |
Features:
Up to IP65 rated enclosure for wet locations, high temperature / flameproof enclosure (80°C max surface rating).
Belongs to Class II+III power SPD
Available in series use
The max. discharge current is 20kA/line.
Having a very low protection level of below 1.3Kv
LED status indicator
This BR-LED-20RL/INS/NG arrestor fulfills the requirements for type 2+3 protective devices according to the current EN 61643-11 product norm.
Small construction size
Application:
Protect vulnerable equipment against the adverse effects produced by voltage spikes.
Protect LED lighting and/or the LED driver.
Suitable for LED Lighting, Roadway lighting, Traffic lighting, Digital signage, Wash wall lighting, Parking garage/lot lighting, Flood lighting, Tunnel lighting, Street lighting etc.
The surge protection device is also suitable for the protection of very sensitive components.
Notice:
After installing, the cable shall not be placed under direct sunlight to avoid expediting aging of the insulating